ANTI-BLAST ANALYSIS OF CELLULAR SACRIFICIAL CLADDING

Ding Yuanyuan; Wang Shilong; Zheng Zhijun; Yang Liming; Yu Jilin

doi:10.6052/0459-1879-14-187

Volume 46 Issue 6

Turn off MathJax

Article Contents

Article Navigation > Chinese Journal of Theoretical and Applied Mechanics > 2014 > 46(6): 825-833

Ding Yuanyuan, Wang Shilong, Zheng Zhijun, Yang Liming, Yu Jilin. ANTI-BLAST ANALYSIS OF CELLULAR SACRIFICIAL CLADDING[J]. Chinese Journal of Theoretical and Applied Mechanics, 2014, 46(6): 825-833. doi: 10.6052/0459-1879-14-187

Citation:

Ding Yuanyuan, Wang Shilong, Zheng Zhijun, Yang Liming, Yu Jilin. ANTI-BLAST ANALYSIS OF CELLULAR SACRIFICIAL CLADDING[J]. Chinese Journal of Theoretical and Applied Mechanics, 2014, 46(6): 825-833. doi: 10.6052/0459-1879-14-187

Citation:

PDF( 9301 KB)

ANTI-BLAST ANALYSIS OF CELLULAR SACRIFICIAL CLADDING

doi: 10.6052/0459-1879-14-187

1 CAS Key Laboratory of Mechanical Behavior and Design of Materials, University of Science and Technology of China, Hefei 230026, China
2 Mechanics and Materials Science Research Center, Ningbo University, Ningbo 315211, China

Funds: The project was supported by the National Natural Science Foundation of China (11372308, 90916026).

Received Date: 2014-06-25
Rev Recd Date: 2014-09-12
Publish Date: 2014-11-18

Abstract

Abstract

The behavior of a cellular sacrificial cladding for blast attenuation was studied by using 1D shock models and 3D cell-based finite element models. Based on a rate-independent, rigid-plastic hardening (R-PH) idealization, a shock model was developed and an equation governing the shock wave propagation in the sacrificial cladding was obtained. The results reveal the shock wave propagation characteristics in the sacrificial cladding. Two parameters, the attached mass and the strength of blasting load, are very important for the cellular sacrificial cladding design. Comparison of the sacrificial cladding structure designs based on the rigid-perfectly plastic-locking (R-PP-L) model and the R-PH model was presented and the applicable conditions of the two shock models were given. Finally, a cell-based finite element model using 3D Voronoi technology was employed to verify the design criteria of the cellular sacrificial cladding structure based on the R-PH model.
- cellular materials,
- sacrificial layer,
- finite element analysis,
- shock wave propagation,
- blast alleviation

FullText(HTML)

References(21)

References

Guruprasad S, Mukherjee A. Layered sacrificial claddings under blast loading Part I — analytical studies. International Journal of Impact Engineering, 2000, 24(9): 957-973

Karagiozova D, Langdon GS, Nurick GN. Blast attenuation in Cymat foam core sacrificial claddings. International of Journal of Mechanical Sciences, 2010, 52(5): 758-776

Liu YD, Yu JL, Zheng ZJ, et al. A numerical study on the rate sensitivity of cellular metal. International Journal of Solids and Structures, 2009, 46 (22-23): 3988-3998

Reid SR, Peng C. Dynamic uniaxial crushing of wood. International Journal of Impact Engineering, 1997, 19(5-6): 531-570

Harrigan JJ, Reid SR, Peng C. Inertia effects in impact energy absorbing materials and structures. International Journal of Impact Engineering, 1999, 22(9-10): 955-979

Tan PJ, Reid SR, Harrigan JJ, et al. Dynamic compressive strength properties of aluminium foams. Part Ⅱ — 'shock' theory and comparison with experimental data and numerical models. Journal of the Mechanics and Physics of Solids, 2005, 53(10): 2206-2230

Harrigan JJ, Reid SR, Tan PJ, et al. High rate crushing of wood along the grain. International of Journal of Mechanical Sciences, 2005, 47(4-5): 521- 544

Zheng ZJ, Liu YD, Yu JL, et al. Dynamic crushing of cellular materials: Continuum-based wave models for the transitional and shock modes. International Journal of Impact Engineering, 2012, 42: 66-79

Wang LL, Yang LM, Ding YY. On the energy conservation and critical velocities for the propagation of a "steady-shock" wave in a bar of cellular material. Acta Mechanica Sinica, 2013, 29(3): 420-428

Zheng ZJ, Yu JL, Wang CF, et al. Dynamic crushing of cellular materials: A unified framework of plastic shock wave model. International Journal of Impact Engineering, 2013, 53: 29-43

Wang LL, Ding YY, Yang LM. Experimental investigation on dynamic constitutive behavior of aluminum foams by new inverse methods from wave propagation measurements. International Journal of Impact Engineering, 2013, 62: 48-59

Cooper GJ, Townend DJ, Cater SR, et al. The role of stress waves in thoracic visceral injury from blast loading: Modification of stress transmission by foams and high-density materials. Journal of Biomechanics, 1991, 24(5): 273-285

Ben-Dor G, Mazor G, Igra O, et al. Shock wave interaction with cellular materials. Part Ⅱ: open cell foams; experimental and numerical results. Shock Waves,1994, 3: 167-179

Li QM, Meng H. Attenuation or enhancement—a one-dimensional analysis on shock transmission in the solid phase of a cellular material. International Journal of Impact Engineering, 2002, 27(10): 1049-1065

Harrigan JJ, Reid SR, Seyed Yaghoubi A. The correct analysis of shocks in a cellular material. International Journal of Impact Engineering, 2010, 37(8): 918-927

Hanssen AG, Enstock L, Langseth M. Close-range blast loading of aluminum foam panels. International Journal of Impact Engineering, 2002, 27(6): 593-618

Ma GW, Ye ZQ. Energy absorption of double-layer foam cladding for blast alleviation. International Journal of Impact Engineering, 2007, 34(2): 329-347.

Liao SF, Zheng ZJ, Yu JL, et al. A design guide of double-layer cellular claddings for blast alleviation. International Journal of Aerospace and Lightweight Structures, 2013, 3(1): 109-133.

Gibson LJ, Ashby MF. Cellular Solids: Structure and Properties, 2nd edn. Cambridge University Press, Cambridge, UK. 1997

Zheng ZJ, Wang CF, Yu JL, et al. Dynamic stress-strain states for metal foams using a 3D cellular model. Journal of the Mechanics and Physics of Solids, 2014, 72: 93-114

王长峰, 郑志军, 虞吉林. 泡沫杆撞击刚性壁的动态压溃模型. 爆炸与冲击, 2013, 33(6): 587-593. (Wang Changfeng, Zheng Zhijun, Yu Jilin. Dynamic crushing models for a foam rod striking a rigid wall. Explosion and Shock Waves, 2013, 33(6): 587-593 (in Chinese))

Relative Articles

Supplements(0)

Cited By

Proportional views