EI、Scopus 收录
中文核心期刊
谢翀 樊菁. Navier-Stokes方程二阶速度滑移边界条件的检验[J]. 力学学报, 2007, 23(1): 1-6. DOI: 10.6052/0459-1879-2007-1-2005-577
引用本文: 谢翀 樊菁. Navier-Stokes方程二阶速度滑移边界条件的检验[J]. 力学学报, 2007, 23(1): 1-6. DOI: 10.6052/0459-1879-2007-1-2005-577
Chong Xie, Jing Fan. Assessment of second-order velocity-slip boundary conditions of the navier-stokes equations[J]. Chinese Journal of Theoretical and Applied Mechanics, 2007, 23(1): 1-6. DOI: 10.6052/0459-1879-2007-1-2005-577
Citation: Chong Xie, Jing Fan. Assessment of second-order velocity-slip boundary conditions of the navier-stokes equations[J]. Chinese Journal of Theoretical and Applied Mechanics, 2007, 23(1): 1-6. DOI: 10.6052/0459-1879-2007-1-2005-577

Navier-Stokes方程二阶速度滑移边界条件的检验

Assessment of second-order velocity-slip boundary conditions of the navier-stokes equations

  • 摘要: 对微尺度气体流动,Navier-Stokes方程和一阶速度滑移边界条件的结果与实验数据相比,在滑移区相互符合,在过渡领域则显著偏离. 为改善Navier-Stokes方程在过渡领域的表现,有些研究者尝试引入二阶速度滑移边界条件,如Cercignani模型, Deissler模型和Beskok-Karniadakis模型. 以微槽道气体流动为例,将Navier-Stokes方程在不同的二阶速度滑移模型下的结果与动理论的直接模拟MonteCarlo(DSMC)方法和信息保存(IP)方法以及实验数据进行比较. 在所考察的3种具有代表性的二阶速度滑移模型中,Cercignani模型表现最好,其所给出的质量流率在Knudsen数为0.4时仍与DSMC和IP结果相符;然而,细致比较表明,Cercignani模型给出的物面滑移速度及其附近的速度分布在滑流区和过渡领域的分界处(Kn= 0.1)已明显偏离DSMC和IP的结果.

     

    Abstract: For micro-scale gas flows, the Navier-Stokes equations with first-ordervelocity slip boundary conditions give results that agree with experimental data in the slipregime, but differ obviously in the transitional regime. Second-ordervelocity-slip boundary conditions were introduced to improve the performanceof the Navier-Stokes equations in the transitional regime. This paperconsiders two-dimensional gas flows through microchannels for which theNavier-Stokes solutions based on different second-order velocity-slipboundary conditions suggested by Cercignani, Deissler, Beskok andKarniadakis, respectively, are compared with the kinetic results given bythe information preservation (IP) method, the direct simulation Monte Carlo(DSMC) method, and experimental data. It is shown that the Cerciganani modelperforms best among the three second-order models we examined, and its massflow rate agrees with the DSMC and IP results even at the Knudsen number of0.4. However, a careful examination of the slip velocities and velocitydistributions at and around the channel surfaces given by the Cercignanimodel demonstrates that they considerately deviate from those given by theDSMC and IP methods at the Knudsen number of 0.1, that is generally regardedas a critical value to divide the slip and transitional regimes.

     

/

返回文章
返回